Waste Oil Boiler CTB-200
The Clean Burn Model CTB-200 waste oil boiler has an input rating of 200,000 BTU/hr and outputs 148,400 BTU/hr. The CTB-200 is UL listed for use in central heating systems.
With CTB-200, you spend 30 minutes cleaning every 750 hours of operation. It is uniquely designed for installation flexibility. Engineered for use as a single boiler unit, or it can be used in combination with any Clean Burn boiler to create a system perfectly sized for any facility.
Need more information? 
Features
- Three-pass heat exchanger creates more heat efficiency
- Low-mass water design provides quick start-up
- Patented burner engineered exclusively for waste oil
- System is pre-wired, ready for installation
- Narrow cabinet designs provide installation flexibility
Specifications
| BTU/hour input: | 200,000 / 58.6 kW | |
| BTU/hour output: | 148,500 / 43.5 kW | |
| Fuels | Used oils: Crankcase, ATF, hydraulic Fuel oils: #2, #4, and #5 fuel oil |
|
| Heating Surface | 39 sq. ft. / 3.6 sqM | |
| Design water flow per coil | 15 gpm / 57 lpm | |
| Cabinet dimensions | 40″ L x 29″ W x 29.5″ H 101cm x 74cm x 75cm |
|
| Overall dimensions (with burner/breach/plumbing) |
59″ L x 33.25″ W x 37″ H 150cm x 84cm x 94cm |
|
| Approx. Weight | 677 lbs. / 304.7 kg | |
| Electrical Requirements | 115 VAC 60 Hz single phase* *230V/ 50Hz units also available |
|
| Maximum oil consumption | 1.4 GPH / 5.3 lph | |
| Stack size | 8″ / 20cm | |
| Air compressor required | 2.0 CFM @ 25 PSI 3.4 m3/h @ 1.7 bar |
|
| Recommended clean-out | 750 hours |
* Values indicated above are nominal. Actual values will vary depending on fuel and installation
Need more information?
